Consultation by phone:

+375 33 698 9999

 

 

Repair of equipment

Presses retrofitting
 
   1. Drawing up of the defective sheet of a press on completeness by a mechanical part and electric equipment.
   2. Full dismantling of all units and disassembling.  
   3. Specification of preliminary made defective sheet on the details demanding restoration or replacement.
   4. Processing of a table, bed, slider, flywheel, etc. and other base parts.
   5. Production of bronze bushes.
   6. Frictionless and slider bearing replacement.
   7. Lubrication system replacement.
   8. Pneumatic equipment replacement.
   9. Electric case production and wiring layout.
  10. Verification
  11. Test-run
  12. Painting and conservation of machine.
  
Turning machine retrofitting
 
   1. Machine cleaning
   2. Machine dismantling, making defect list
   3. Frame renovation
   4. Apron renovation
   5. Carriage renovation
   6. Feed box renovation
   7. Electric equipment renovation
   8. Transmission renovation
   9. Support renovation
  10. Back stock renovation
  11. Renovation of a back support, moving shaft, turning shaft, worm gear.
  12. Assembling of the machine
  13. Verification
  14. Painting and conservation of the machine.
Milling machine retrofitting
 
   1. Machine cleaning
   2. Machine dismantling, making defect list.
   3. Frame guide ways renovation.    
   4. Transmission renovation.
   5. Spinel head renovation.
   6. Table renovation, crosswise and lengthway feed guide ways.
   7. Feed box renovation.
   8. Renovation of a screw-nut for lengthwise, crosswise and vertical feed.
   9. Lubrication system renovation
  10. Electric equipment renovation (controlling all lathe parts by control panel without programming)
  11. Assembling and setting of the machine
  12. Verification
  13. Painting and conservation of the machine.

 

 

 

Заказать дипломную в Минске курсовую, контрольную